Pre-drill pilot hole into Ipe deck board using a 9/64" drill bit and adjustable drill stop to prevent drilling into joist or framing member.  DO NOT DRILL INTO FRAMING MEMBER!

After drilling pilot hole, place the T-10 Gold screw insert/driver tip into top of pilot hole. Apply pressure and depress drill for a few seconds. The insert tip's special design will create a counter-bore to accommodate the TrimTite head perfectly. This will minimize screw breakage and stripping.

Using a slow and steady speed, insert TrimTite screw into pilot hole using the T-10 insert/driver tip.

If necessary, spot sand above screw head using a sanding block or a small piece of sand paper to remove any possible burr. Any grit will suffice.

ATLANTA, GEORGIA    USA         Toll Free: 1-877-909-8575         GA (in state): 770-953-0303

  ORDER INFORMATION

  SHIPPING

  CONTACT US

              Ipe Decking     Ipe Furniture     Deck Railing     Hardwood Flooring     TrimTite screws     DeckTite screws     Ipe Clip     Accessories

                            Quikdrive screws     Headcote screws     Photo Gallery     S.S. Nails     S.S. Bolts        www.ipedeckingsource.com